Diseño de sistema de control para telar plano de doble pasada
Cargando...
Fecha
2019-07-04
Autores
Enlace al recurso
DOI
ORCID
Google Scholar
Cvlac
gruplac
Descripción Dominio:
Título de la revista
ISSN de la revista
Título del volumen
Editor
Universidad Santo Tomás
Compartir
Documentos PDF
Cargando...
Resumen
Este proyecto hace referencia a la realización del diseño de un sistema de control para un telar plano de doble pasada, para la fabricación de tela, destinada a la elaboración de sombreros y mochilas de la empresa Artesanías ALROL de Colombia, que está ubicada en la ciudad de Tunja.
A partir del análisis del funcionamiento de los sensores, es importante que las especificaciones técnicas, manuales de funcionamiento y cartillas de mantenimiento estén en español, ya que de lo contrario será una limitación importante para el desarrollo de la empresa, por consiguiente, la única información que se encontró esta en chino e infográficamente no se encuentra datos de estos.
Mediante el estudio de fuentes e alimentación trifásicas, se llego a concluir que la más viable a utilizar es la RQ125-D, ya que esta nos genera los voltajes óptimos para el diseño de control, porque cuenta con salidas de 12V y 5V.
Se realizó el estudio de sensibilidad de los optoacopladores para que este dispositivo realizara la conexión entre dos circuitos, de tal forma que quedarían unidos ópticamente, lo que hace efecto de protección del circuito, se realizarón pruebas con diversos valores de resistencias, hasta llegar a los adecuados para lograr una protección contra los picos de tensión del PIC18F4550, de los sensores y el relé que va al motor, disminuyendo costos para la empresa al no tener que comprar un dispositivo especializado para esto.
Abstract
This Project refers to the realization of the design a control system for a doublé-looped flat loom, for the manufacture of cloth, destined to the manufacture of hats and backpacks of the Company artesanías ALROL the Colombia, which is located in the city of Tunja.
Based on the analysis of the functioning of the sensors, it is important that the technical specifications, operating manuals and maintenance books are in Spanish, since otherwise it will be an important limitation for the development of the Company, therefore the only information that it was found in Chinese and infographically there is no data of these.
Through the study of three-phase power supplies, it was concluded that the most viable to use is the RQ125-D, since it generates the optimal voltajes for the control design, because it has outputs of 12V and 5V.
The sensitivity study of the optocouplers, was carried out so that this device could make the connection between two circuits, in such a way that they would be optically united, which makes the protection effect of the circuit, tests were carried out with different values of resistances, until reaching the suitable for protection against the voltaje peaks of the PIC18F4550, the sensors and the relay that goes to the motor; reducing costs for the Company by not having to buy a specialized device for this.
Idioma
spa
Palabras clave
Citación
León Vargas, L. D. (2019). Diseño de sistema de control para telar plano de doble pasada.Tesis de pregrado. Universidad Santo Tomás. Tunja.
Colecciones
Licencia Creative Commons
CC0 1.0 Universal